Vt4888 Array Wiring; Vt4889 - JBL VerTec VT4889 System Configuration Manual

JBL VerTec VT4888 Line Array
3 x Power Amplifiers
(2Ω Load on LF Passband)
IMPORTANT NOTES
All wiring configurations shown above use 8-conductor speaker cables terminated with Neutrik NL8 "Speakons".
Ensure that each conductor in the cable is a minimum of #13 AWGuage (3-4mm).
JBL VT4888:
The HF section of a VT4888 has two 2431H drivers (8Ω) wired in Series.
The MF section of a VT4888 has four 2106H drivers (8Ω) wired in Series / Parallel
The LF section of a VT4888 has two 2262H drivers (8Ω) wired Independently
Page 10
Power Amplifier configurations - 4 Box Array
4 x Power Amplifiers
OR
(recommended)
=16Ω Pins 4±
=8Ω Pins 3±
=8Ω / 8Ω Pins 2± / 1±