Table of Contents
Advertisement
48
D
escription of the interface.
D
escription of the operation LEDs.
Green LED
On: Divert mode enabled.
Off: Divert mode disabled.
Red LED
On:
Power on.
Blinking
: Programming mode.
Off:
Power off.
D
etail of the interface's installation.
The interface can be installed on a DIN guide (10
elements) by gently pressing it in. To extract the interface
from the DIN guide, use a plain screwdriver to lever the
flange as shown in the picture.
f3,5 x 45
Connection block
Operation LEDs
DIN rail latch release
f3,5 x 45
To install the interface directly on the wall, drill two holes of
4 N
-
I T
Install the interface in a dry, protected place.
The operation LEDs are beside the
configuration dip switch.
Ø6mm. and insert the wallplugs. Fix the interface
with the specified screws.
DESCRIPTION
INSTALLATION
DIN 46277
Advertisement
Table of Contents
