Table of Contents
Advertisement
44
Communication with the telephone line, outgoing call, call divert:
When the interface has the call divert function enabled, any calls made from the door entry
O
system to the apartment will be diverted to the telephone numbers previously programmed in the
interface. A maximum of three telephone numbers can be programmed. The calls are made in a
cyclic order whereby the first number programmed is called, and if it is not answered, then the
second number is called, and so on.
To initiate communication when the programming field "72" (pickup detection) is set to "1", pick
O
the handset up, and press the " " key.
Audio communication with the door entry system is established when the call is answered, and
O
the following commands can be sent using the telephone's keypad:
"5" Door opening.
Ü
"0" Triggers the auxiliary relay used for activating auxiliary devices (bells, lights, ...).
Ü
The volume levels of the microphone and speaker can be adjusted during communication with
O
the audio door entry system using the telephone's keypad:
"1" Increases the audio door panel's speaker volume.
Ü
"7" Lowers the audio door panel's speaker volume.
Ü
"4" Confirms and memorises the changed volumes for the audio door panel's speaker.
Ü
"3" Increases the telephone's speaker volume.
Ü
"9" Lowers the telephone's speaker volume.
Ü
"6" Confirms and memorises the changed volumes for the telephone's speaker.
Ü
When a call is received from the telephone line during communication with the audio door entry
O
system, a tone from the telephone's speaker will be heard. Use the corresponding functions of this
telephone to switch between the call from the door entry system and the current call.
To realize this function, the user must have the service of call waiting
In noisy locations where fluent communication is difficult, the user can press the "8" key to
O
activate the function "talk/listen" between the audio door panel and the telephone. Press the "8"
key to toggle the communication channel.
To end communication, replace the telephone handset.
O
To end communication when the programming field "71" (divert type) is set to "1", press the " "
O
key then replace the handset.
Notes:
Calls can be diverted to telephones on fixed-line or cellular networks, or to extensions on private
O
telephone networks, with this last option requiring the PABX to be installed in the same system as
the telephone interface.
The quality of the audio communication in call divert mode will depend on the network and the
O
type of terminal that receives the call, and if the call is diverted to a cellular telephone which is in a
noisy location, this will also have an influence.
*
SYSTEM OPERATION
.
*
Advertisement
Table of Contents
