Related Manuals for JL Audio M-MCPv3
Summary of Contents for JL Audio M-MCPv3
- Page 1 Installation Instructions for M-MCPv3 fixed-mount fixtures for round pipes PI PE M O U N T I N G FIX T U R E S (FIXED) FOR ETXv3 ENCLOSED SPEAKER SYSTEMS...
- Page 2 5/16 - 18 x 1-1/4” Machine Screw * Supplied with ETXv3 speaker system. NOTE: The M-MCPv3-2.000 Fixture and M770-ETXv3-SG-WH Enclosed Speaker System are used in this manual for illustrative purposes only. The fixture installation steps are the same for all ETXv3 Enclosed Speaker Systems and all...
- Page 3 Wiring Information (LED models only): Example: One speaker pair of Fuse Blue Blue LED circuits connected in parallel. Yellow Yellow [GND] [+12V] Fuse Fuse Blue Blue Yellow Yellow Fuse Blue Blue Yellow Yellow Example: Two speaker pairs of Fuse Blue Blue LED circuits connected in parallel.
-
Page 4: Installation Procedure
Installation Procedure: There are two speaker cable routing options. For For applications where the cable can be routed applications where the cable cannot be routed through the pipe, the cable can be passed through through the pipe, the cable can be passed through the opening in the bottom of the Lower Fixture. - Page 5 Compound to the screw end, reinstall, and fully tighten. Repeat the process for the other three screws. Remove adhesive backing and install the JL Audio If a different speaker angle is desired, remove the #8 logo badge (Sport Grille Models Only).
- Page 6 Rotate the speaker to the desired angle. Reinstall the For best adhesion, it is recommended to clean the #8 x 1-1/4" Pan Head Screws and #8 Flat Washers. inside of the aluminum cap with acetone (not included) prior to attaching it to the enclosure. Apply a circular bead of Silicone Adhesive to the inside of the aluminum logo cap, about 1/2-inch (13 mm) from the outer edge.
- Page 8 . j l a u d i o . c o m JL Audio® and the JL Audio logo are registered trademarks of JL Audio, Inc. “Ahead of the Curve” and it’s respective logo is a trademark of JL Audio, Inc.
Need help?
Do you have a question about the M-MCPv3 and is the answer not in the manual?
Questions and answers