Advertisement
INSTALLATION INSTRUCTIONS
CAUTION: Do not use the tweeter-mounting baffle as a handle to
move, carry or position the speaker. Doing so can damage the
baffle. Such damage is not covered by the speaker's warranty.
JBL architectural speakers are extremely easy to install. However, if you
are unable to understand and follow the instructions in this manual clearly
and fully, or if you are unsure of your ability to install these loudspeakers
properly, please contact your dealer or a qualified installer.
WARNING: HARMAN International assumes
no responsibility for improper installation of
hardware or for any personal injuries or product
damages resulting from improper installation or a
fallen loudspeaker.
4
CONNECTING TO THE AMPLIFIER
CAUTION: REMOVE POWER
You must connect the speaker wires before the speaker is fully
installed. To protect the audio system and yourself from damage
or injury through accidental electrical shorting and surges during
installation, turn all audio system power OFF before beginning the
speaker installation.
Speaker Wire
Use high-quality speaker wire to obtain the best performance from your
JBL in-ceiling speakers.
• For wire lengths of less than 50 ft (15m), use at least 16-gauge
speaker wire.
• For wire lengths between 50 ft and 100 ft (15m – 30m), use at least
12-gauge speaker wire.
• For wire lengths of greater than 100 ft (30m), use at least 10-gauge
speaker wire.
Note: All speaker wires must comply with all local building and safety
codes for use in in-ceiling applications.
Making Connections
Connect each channel's positive (+) terminal on the back of the amplifier
or receiver to the positive (red) terminal on the corresponding speaker;
connect each channel's negative (–) terminal on the back of the amplifier
or receiver to the negative (black) terminal on the corresponding speaker.
Do not reverse polarities (that is, do not connect + to –, or – to +) when
making connections. Doing so will cause poor imaging and diminished
bass response.
Negative Terminal
(Black)
Press down on the post to open the hole; insert the bare end of the wire
into the hole and release the post to secure the wire.
CAUTION: To avoid short circuits that may damage your
equipment, be certain that positive and negative wire strands do
not touch each other and do not touch metal parts such as the
speaker frame.
JBL Arena In-Ceiling Architectural Loudspeaker
Positive Terminal
(Red)
Instruction Manual
Advertisement
