LaserLiner ClimaPilot Operating Instructions Manual page 6

2
ON / OFF
To turn on, set the switch (5) to ON. The device
displays the ambient temperature and relative
humidity.
When switching to a measuring location with significantly
!
different temperature and humidity levels, allow the device
time to adapt!
!
For measurements outside of the measuring range, the device
displays „HI" or „LO".
3
Dew point display
By briefly pressing the „MODE" button, the measured dew point is
displayed.
4
MAX / MIN
To determine the maximum or minimum measured values during a
measurement, press and hold the „MAX / MIN" button until either
„MAX" or „MIN" appear on the display. The normal measuring
mode is set when no function flashes on the display.
!
Switching off the device deletes the min/max values.
5
°C / °F
To set the desired temperature unit, press and hold the „MODE"
button for 2 seconds until the corresponding symbol appears
on the display.
Notes
– This product is a precision instrument which must be handled
with care. Avoid impact and vibration as well as exposure to
extreme heat or cold.
– Avoid direct contact with liquids.
– Clean with a soft, damp cloth.
06
EN
ON OFF