EasyWater RevitaLife Installation Manual And Owner's Manual page 8

Installation
TANK VALVE INSTALLATION - PLASTIC TANK
Make sure the O-ring is located at the bottom of recess
1)
for the tank connection.
Thread the plastic tank shut-off valve onto the tank fitting.
2)
Hand tighten only. Do not over tighten or the valve
could crack.
NOTE: Tank can stand vertically or lay horizontally.
DRAIN SADDLE INSTALLATION
Drain Saddle fits standard 1 ¼" – 1 ½" drain pipes
Important: When installing under a sink, the drain saddle will be installed on the vertical drain
pipe (tailpiece), above the p-trap. The drain line installation must be either above the disposal, or if
a second sink drain is available, install it above the cross bar on the second sink. Installation of the
drain saddle below where the outlet of a garbage disposal connects to the vertical drain pipe may
cause the drain line to plug.
»
Verify contents prior to installation
(2) Screws with nuts
(1) Semicircle bracket with opening
(1) Semicircle bracket
(1) Foam gasket
Apply the adhesive-backed foam gasket to the inside of the semicircle bracket with opening,
1)
aligning holes.
Drill a ¼" hole through the sink's drain pipe at least 1 ½" above the connecting nut of the P-trap;
2)
be sure to allow for future removal of the P-trap. Place the drain saddle around the drain pipe,
positioning the drain saddle over the drilled hole in the pipe. To ensure proper alignment, insert
a screwdriver through the opening of the drain saddle and the drilled hole in the drain pipe.
Tighten screws evenly and securely on both sides of the drain saddle.
Caution: Do not over tighten the screws. This may crack the drain saddle.
RevitaLife | Installation Manual & Owner's Guide
(Cont'd)
7