EasyWater RevitaLife Installation Manual And Owner's Manual page 6

Installation
TOP MOUNT FAUCET INSTALLATION
Mounting hole size: Minimum 1" ; Maximum 1¼"
Max torque on toggle bolt: 5 lb. in.
Remove faucet base and faucet spout from bags. Ensure that 2 black O-rings and 3-prong
1)
plastic spacer are attached to the base of faucet spout, as pictured above.
Attach blue tubing to the bottom of the toggle bolt on faucet base. Remove adhesive backing
2)
from faucet base.
Feed the faucet tubing and toggle bolt down through the hole in sink. Ensure that the rubber
3)
gasket is uniformly positioned between the base and sink.
Align faucet base with handle on right side and base sitting on top of sink. Turn the handle down
4)
(towards you) to the "on" position to reveal the tightening screw (located where the spout will
be inserted). Using a Phillips head screwdriver, turn the screw clockwise until the toggle bolt
secures the faucet base snug on the sink top.
When faucet base is securely fastened to the sink, insert the faucet spout into the faucet base
5)
until it is fully sealed. Do NOT remove O-rings or plastic spacer on faucet spout base. Turn the
handle to the "off" position.
Proceed to Adapt-A-Valve Installation.
6)
RevitaLife | Installation Manual & Owner's Guide
(Cont'd)
5