Connecting The Rjp(Remote Jack Pack) - Samsung LN2A620A1F User Manual

Connecting the RJP(Remote Jack Pack)

This function is only available when the TV is installed in a hotel.
➣
RJP Rear
4
Output of any external source connected to RJP on hotel desk.
1.
Connect the PC IN [PC] / [AUDIO] port of the TV to the PC/AUDIO port of the RJP.
2.
Connect the AV IN [VIDEO]/[R-AUDIO-L] port of the TV to the RCA port of the RJP.
3.
Connect the S-VIDEO / AV IN[R-AUDIO-L] port of the TV to the S-VIDEO port of the RJP.
You cannot connect and use the AV and S-VIDEO ports at the same time.
➣
4.
Connect the [HDMI] port of the TV and the HDMI port of the RJP.
5.
Connect the EX-LINK port of the TV and the RS/232 port of the RJP.
The RJP (Remote Jack Pack) compatible with this Samsung TV is TeleAdapt TA-7610.
➣
RJP (Remote Jack Pack)

RJP stands for Remote Jack Pack. The RJP is a hardware module that has different Audio Video inputs (A/V, S-Video,
Audio, PC and HDMI) and corresponding outputs. The corresponding output sources are connected from RJP to
TV. The RJP communicates with the TV via RS232. Hot Plug & Play is a function that allows hotel guests to connect
an external source to the RJP. The RJP communicates with the TV by sending messages regarding Active/Inactive
sources. The TV will switch to the Active external source according to the priority set by the User.
You have to connect the HDMI of the RJP to the HDMI 1 port of the TV.
➣
When the TV is on, connect the TV and the RJP within 10 seconds.
➣
Some HDMI Cables may not support RJP Function because RJP HDMI input impedance is high. If the connected
➣
HDMI device is not displayed, check whether or not the HDMI cable is properly connected or change the HDMI
Cable.
The RJP can be returned to the factory default settings by pressing the A/V and HDMI buttons simultaneously

for 10 seconds. All LEDs blink  times to acknowledge that the rest has been performed.
The RJP will automatically turn off any LEDs after  minutes to avoid unnecessary light pollution in the hotel

room. The LEDs that were turned off will turn on again if the guest touches any of the buttons and the 
minute timer will restart. If the guest then touches another source button, the TV will change to the selected
source and the corresponding LED will be lit.
After an RJP Reset or a TV Power OFF/ON, it takes approx. 10 seconds to establish communications between

the TV and the RJP.
S-Video / Audio Cable

Video / Audio Cable
2
or

D-sub / PC Audio cable
1
HDMI cable
English - 12
TV Rear Panel
TV Side Panel