After the flame is extinguished remove the regulator and check the condition of its seal. Replace the seal if in doubt. Re-light the appliance as described in Section 3 below. Should the flame light back persistently return the product to your authorized CADAC repair agent.
A formation of bubbles will indicate a gas leak. Check that all the connections are securely fitted and re-check with soapy water. If you cannot rectify the gas leak, do not use the appliance. Contact your local CADAC stockist for assistance.
This Warranty applies only to products sold at retail. To enjoy and ensure longevity of your CADAC product, please refer to the cleaning and maintenance section of the user manual with particular attention to the care of the Stainless Steel.
Page 6
12. Assemblies cont. 12.1 Side Tables Step 1 Step 1a Step 1b Step 2 Step 3 Step 4 Step 4a Step 5 Step 5a • Repeat the above steps for the left side table.
Page 7
12. Assemblies Cont... 12.2 Burners Warning!: Please remove the plastic jet cover before installing the burner (Step 1a) Step 1a Step 1b Step 1c Step 1d Step 1e 12.3 Chopping Board Step 1a Step 1b...
Need help?
Do you have a question about the Braaimaxx and is the answer not in the manual?
Questions and answers