Advertisement
Note: The ALTITRACK goes out of ACCESS if no button has been pressed within 5 sec.
Note: When performing zeroing the ALTITRACK enters Jump Mode (see chapter "Jump
Mode") and remains in Jump Mode for 5 hours, if no jump is made.
After 5 hours the ALTITRACK recalibrates to its current local elevation.
Jump Mode
Shortly after take-off the "airplane icon" on the digital display starts to flash,
indicating that the unit has switched to Jump Mode.
Main Display
After landing the jump data is displayed on the LCD.
Press
to display Logbook Screen # 1. (Main information)
Example
The information includes:
- Jump number
- Freefall time
- Speeds (scrolls automatically through AVG, MAX and MIN)
- Exit altitude
- Deployment altitude
To scroll through the previous jumps, press
and to scroll forward, press
again to display Logbook Screen # 2. (Playback, Jump Profile)
Press
Example
The information on the display includes:
- Time after exit in seconds and ¼ seconds
- Speed at time
- Temperature inside instrument at exit and then updated every 30 sec.
- Altitude at time
- Freefall and canopy status
Press
to playback the jump profile and press
reverse.
Press
to stop playback.
Press
again to display Logbook Screen # 3. (Date, Time and Dive Type)
The information on the display includes:
- Jump Date - Jump Time - Dive Type
To scroll through the previous jumps press
Battery Status
Full capacity: Symbol shows two black bars inside the battery icon.
Half capacity: Symbol shows one black bar inside the battery icon.
Low capacity: Symbol shows no black bars, just an "empty" battery icon.
Battery should be replaced as soon as possible.
The "Low bat" flashes once every 15 sec.
Caution: Do not make night jumps at sub zero temperatures when bat. shows
low capacity.
Empty battery: The battery icon flashes. Replace battery immediately.
Customise the ALTITRACK Settings
If you want to customise each setting, please read the manual. If you only want to
customise the most important settings prior to the first jump (Total number of
jumps, Date and Time), continue reading below.
To enter the SETUP Selector:
Press and hold
To leave the SETUP Selector:
Wait until the display times out or,
press
or
to exit.
to playback the jump profile in
NOTE: If no button has been pressed within 5 minutes after choosing any SETUP
window, the ALTITRACK will return to the Main window (showing Time, Temperature
and Altitude).
Example
To change direction, press
for 3 seconds.
repeatedly until returning to the Main Setup Display, then press
} Toolbar
}
Factory default set-up.
Main Setup Display
Example, Main window
Press
repeatedly to select TOTAL
Press
("TOTAL" flashes).
Example
Press
to increase the jump total.
Press
to decrease the jump total.
Press
to store the new total number of jumps and end.
Press
again to select "Clock/DATE" icons
Press
("Clock" icon flashes).
Press
to increase date value.
Press
to decrease date value.
Press
to store the new date and end.
Note: Date format is YYYY:MM:DD.
Press
again to select "Clock/TIME" icons
Press
("Clock" icon flashes).
Press
to increase time value.
Press
to decrease time value.
Press
to store the new time and end.
Note: Time format is 24 hours
Advertisement
