Barco TransForm A User Manual page 117

Detects automatically the visible portion of the signal and positions it in the video window.
Detect Position
If selected this applies each time the signal changes or gets reconnected.
Only applicable with D
Edit the preset.
Edit Preset
Create new preset.
New Preset
When starting to display an analog RGB-source or an analog YUV source the settings of the source are automati-
cally detected as long as the default setting Detect Position remains on and Auto is selected in the Presets list.
The D RGB I C
UAL NPUT ARD
as of the position. In most cases this results in settings to optimally display the RGB or YUV data. If anyhow auto
detection sets a preset with e.g. a different resolution, then, if you know the timing of the incoming signal, se-
lect this timing from the preset list, the video software will position the source in respect of the newly selected
timing.
Depending on the version of the controlware of the D
different to the given description, which is based on version 3010-02. Please, refer in this case to section
Configuration of analog RGB and YUV
To check the version of the controlware you can use the device explorer, please refer to section
6.1.13 Device
Barco – TransForm A - Workstation for Windows – DOC-3266-2 – Revision 16 – August 2007
RGB I
UAL
and the D DVI I C
UAL NPUT ARD
input.
Explorer.
C with controlware CTW-3010-02 or later.
NPUT ARD
perform complete auto detection of the screen mode as well
RGB I C , auto detection might behave slightly
UAL NPUT ARD
____________________________________________________________
4. Operating
Table 4-17
Video dialog box – D RGB I
UAL NPUT
C
ARD
4.3.10
4-37