Holland FW0070 Installation, Operation And Maintenance Manual page 8

Installation Procedures
3.3 Bracket with Mounting Base
1. HOLLAND brackets with mounting base
®
are intended for installation on either
corrugated or flat mounting plates.
2. In addition to the information given in
"Installation: General Recommendations"
on Page 4, follow the recommendations in
Figures 4, 5, and 6.
IMPORTANT: Attach the outboard angle to
tractor frame with hardware
listed in Figure 1. Attach
mounting plate to angle with
the same number of bolts (in
addition to attachment to
fifth wheel support bracket)
(Figure 4 and 5).
IMPORTANT: Attach bracket and mounting
plate as illustrated (Figure
6). Use center bolt of
sufficient length to bolt
through bracket, mounting
plate and mounting angle.
3. Refer to "Installation: General
Recommendations," on page 4, for angle
thickness and material. The mounting
angle should be 1" longer than the
mounting plate, and be 36" minimum
length. Use 3" minimum horizontal and
3-1/2" minimum vertical leg size. Longer
horizontal legs may be required with
narrow frame widths.
8
Figure 4
Figure 5
Figure 6
XL-FW482 Rev C · 2016-07-05 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,
and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
FIFTH WHEEL
SUPPORT BRACKET
FLAT MOUNTING
PLATE REFER TO TABLE
1 FOR MINIMUM
THICKNESS
SPACER
INBOARD ANGLE
TRACTOR FRAME
FIFTH WHEEL
SUPPORT BRACKET
CORRUGATED
MOUNTING PLATE
REFER TO TABLE 1 FOR
MINIMUM THICKNESS
SPACER
INBOARD ANGLE
TRACTOR FRAME
CENTER BOLT