Table of Contents
Advertisement
Remove six large screws from the rear side of the display.
4
Insert the bolts, dish-type washers, and insulation holder into the
5
holes
as shown in the following figure:
ΠBolt
´ Insulation holder
Hang the protruding plastic part on the rear of the PDP up the groove on the
6
top of the wall attachment panel. Then, lift down the PDP.
(Do not lift down the PDP with too much force. The protruding plastic part
might be taken off.)
16
six screw-
Œ
´
Advertisement
Table of Contents
