Summary of Contents for Handler 16 CHUK/CHANGER
- Page 1 16 Chuk/Changer Maintenance Instructions IMPORTANT INSTRUCTIONS WARNING! FOR YOUR SAFETY PLEASE READ INSTRUCTIONS BEFORE OPERATING TOOL & WEAR EYE PROTECTION 017-0092.06/2009...
- Page 2 After you have contacted the freight forwarder, please contact your distributor advising that you have received a unit which sustained damage, detailing the possible damage and requesting they contact Handler. Possible damage MUST BE CLAIMED by the receiver of the product, not the sender. CAUTION!
-
Page 3: Safety Instructions
ALL ELECTRICAL ITEMS WITH A CORD SET: REPAIR OR REPLACE DAMAGED OR WORN CORD IMMEDIATELY. DO NOT ExPOSE TO RAIN OR USE IN DAMP LOCATIONS. ADVERTISSEMENT: NE PAS ExPOSER A LA PLUIE ET NE PAS UTILISER DANS LES EMPLACEMENTS HUMIDES. 16 Chuk/Changer Instruction... - Page 4 NOTE: Many Red Wing polishing motors are shipped with 1/2” straight shafts. Chucks used on Red Wing Polishing motors equipped with a 1/2” straight shaft utilize a set screw to hold the chuck in position. Make certain to tighten this securely. 16 Chuk/Changer Instruction...
- Page 5 NOTE: Should the clutch handle stop before the 9:30 o’clock position, the adapter set screws should be loosened and the QUESTIONS? Review FAQ section on our website at: entire chuck assembly pulled away from the the lathe. www.handlermfg.com or call 1-908-233-7796. 16 Chuk/Changer Instruction...
-
Page 6: Parts And Accessories
1-1/2” cutoff wheels No.10B Clutch complete for all Baldor lathes No.21HS Screw only, 2-64 for No. 21H No.10RM Clutch complete with bearing for all No.22 Bearings Robbins-Myers lathes No.10R Clutch complete with bearing for all Ritter lathes 16 Chuk/Changer Instruction... -
Page 7: Important Notice
Your Chuk/Changer has been manufactured, assembled, adjusted and tested with the utmost of care to insure that you will receive it in perfect condition. We ask that you carefully read and follow these step by step instructions. 16 Chuk/Changer Instruction... -
Page 8: Installation And Maintenance
If squeaking persists and there is a presence of excessive amounts of dust around the clutch area, the adapter is improperly mounted, causing misalignment of the clutches. Refer to installation instructions for your model lathe. 16 Chuk/Changer Instruction... -
Page 9: Operation And Care Instructions
See instructions under removing chuck from lathe. Grasp the steel clutch plate to keep it from turning while you remove the collet. *However, make certain collets have been properly cleaned. Dirty collets may also cause chuck slippage. 16 Chuk/Changer Instruction... - Page 10 Do not wear loose clothing or jewelry which may get caught in moving parts. Tie back 14. Avoid Accidental Starting this and any other long hair or use a proper hair net. appliance. Be sure switch is OFF when plugging in. 16 Chuk/Changer Instruction...
- Page 11 IMPORTANT NOTICE WHAT SHOULD YOU DO TO RETURN GOODS 1. Our terms of sale are F.O.B. our plant. Handler makes every effort to insure the proper delivery of goods, but we cannot guarantee the carrier’s performance. Each product is tested and inspected for proper performance prior to leaving our facility.
-
Page 12: Warranty
WARRANTY This HANDLER product is warranted to be free from defects in material and workmanship, when used under the conditions recommended by the manufacturer, and/or the purpose for which the product was intended, for a period of 12 months from the date of shipment from factory to job site of original owner.