Starting A Wash Cycle; Changing A Wash Cycle - EdgeStar DWP62BL Owner's Manual

Starting a Wash Cycle

Once the dishwasher is fully loaded follow these procedures to start the wash cycle:
 Ensure that the unit is connected to the power supply.
 Ensure that the water supply is turned on to full pressure.
 Pour in the detergent.
 Verify that enough rinse aid is in the dispenser, if desired.
 Close the door and press the ON/OFF button to power the dishwasher on.
 Press the program button to select the desired wash cycle:
Heavy -> Normal -> Light -> Glass -> Baby Care -> Speed -> Rinse
 Press the +/- buttons to adjust the delay setting if desired.
 Press the START/PAUSE button, the dishwasher begins to start. If a delay time was selected,
the dishwasher will start after the delay.
Note:
 When the Start/Pause button is pressed during a wash cycle the cycle is suspended and
the display time will stop blinking. The program will remain paused until the Start/Pause
button is pressed again to continue the cycle.

Changing a Wash Cycle

You can modify the washing cycle, but only when the dishwasher has been running for a short time.
Otherwise, detergent may have been released, and the appliance may have already drained the
water. If this is the case, the detergent dispenser must be refilled.
Caution:
 Opening the door during the wash cycle may result in injury from scalding hot water.
 Ensure that wash cycle has fully stopped before opening the door to refill the detergent
dispenser if necessary.
Pressing the START/PAUSE button for three seconds or more will put the machine in a stand-by
state. At this point the cycle setting can be changed.
Note:
 If the door is opened during the wash cycle, the machine will be paused. Once the door is
closed, you need to press the Start/Pause button to continue the cycle.
14