Table of Contents
Advertisement
Safety Warnings and Notices
−
Always return the Output Voltage control to Min when a test is complete. Begin each
test at the Min voltage setting. Failure to do so may result in damage to the test winding
and/or the tester.
Symbols on equipment
Other Information
Cleaning & decontamination
The ST103A, ST106A, or ST112A should be kept clean and in a dry environment. To clean
the unit, power down and unplug the instrument. Wipe with a clean water dampened cloth.
Do not submerge in water or other cleaners or solvents. To clean the screen, take a soft
water dampened cloth and gently wipe the surface.
Technical assistance / Authorized Service Centers
See our website at
www.bakerinst.com
information. This information will be marked with an asterisk.
Intermittent operation limits
At this time there are no intermittent operation limits to the use of the AWA unit.
Installation requirements
The unit may be operated
1)
Flat on the bottom of the unit,
2)
Flat on the back of the unit, or
3)
Held at an angle using the rotating handle.
There are no ventilation requirements.
The unit is intended for use in Installation Category II (Portable Equipment) areas and
pollution Degree II Environments where occasional non-conducting condensing pollution can
be encountered.
Unpacking the unit
Carefully remove the following items from the shipping boxes.
ST103A, ST106A or ST112A
Power cord
12/7/2009 | 71-026 V2
PP24
Protective conductor terminal. Located beside black ground test lead
on front panel of instrument.
Earth (ground) terminal
Frame or chassis terminal. Located on rear panel of instrument by
ground terminal.
Warning about hazardous voltage and risk of severe electrical shock or
death. Located beside each red test lead on front panel of instrument.
for technical assistance/authorized service center
7
- Quick Links:
- Surge
Hide quick links:
Advertisement
Table of Contents
