Advertisement
Available languages
Available languages
Carefully inspect the condition of the pole before climbing. Failure to do so could result
in serious injury or death. If there is any doubt as to the strength and integrity of the
pole, do not attempt to climb it.
The StopFall Device is designed for use with Miller approved components. Substitution or
replacement with non-approved component combinations or subsystems or both may affect
or interfere with the safe function of each other and endanger the compatibility within the
system. This incompatibility may affect the reliability and safety of the total system.
A linemen's belt with four D-rings, such as the Miller Black Beauty Model 8449-1, and a back-
up positioning and fall restraint device, such as the Miller Adjustable Rope Lanyard Model
ARL-100-Z7, is recommended for use with the StopFall Device.
Fall protection components used with this product must be rigged in accordance to
regulatory requirements. [All instructions and warnings provided with the components
must be read, understood, and followed.]
Make sure that all connections within the fall protection system are compatible.
4.1 Installing and Adjusting the StopFall
Warnings
ing action during a fall. Failure to do so could result in serious injury or death.
tions during the climb/descent. Never detach the StopFall during use unless the back-
up device is in place.
tained at the minimum comfortable length possible for the application.
linesman's waist belt, refer to Figure 4.
Fig. 4
Y-30cm
Y-42cm
Expected Total Fall Distances
Position 1
1
Position 2
2
7
-
-
-
-
Advertisement
