Samsung SIR-S60W Owner's Manual page 18

Setting Up and Connecting
Advanced Connection Set Up Steps:
1
Make sure the power cords for your Multi-Satellite Receiver, TV, and VCR are
unplugged before connecting any of the cables.
2
Connect your satellite dish antenna to the SATELLITE IN jack on the back of
the Multi-Satellite Receiver with RG-6 coaxial cable running from the dish.
3
Connect your cable or off-air antenna to the IN FROM ANTENNA jack on the
back of the Multi-Satellite Receiver with the coaxial cable running from the
cable system or installed off-air antenna.
4
Connect the Multi-Satellite Receiver TEL LINE jack to a telephone wall jack
with the included telephone cord.
5
Connect the Multi-Satellite Receiver TV OUT jack to the IN FROM ANT
terminal on the VCR with the included short coaxial cable.
6
Connect the VCR OUT TO TV jack to the IN terminal on the TV with a short
coaxial cable (not included).
7
Connect the red and white audio cables from the R-Audio-L jacks on the
back of the Multi-Satellite Receiver to the AUDIO jacks on the TV. Please be
sure to match the colors on the jacks with the same colors on the included
audio cables.
8
Connect the yellow video cable between the VIDEO jack on the back of the
Multi-Satellite Receiver to the VIDEO jack on the TV.
9
Connect the power cords for your Multi-Satellite Receiver, TV, and VCR to
wall outlets.
To watch DIRECTV programming
Set your TV to the appropriate A/V mode (TV input selection).
If you have difficulty setting this A/V mode (TV input selection), refer to your TV
owner's manual.
To record DIRECTV programming
Tune your Multi-Satellite Receiver to the desired channel and set your VCR to record
on channel 3 or 4, depending on your setting for the default TV output channel.
To view VCR recordings
Tune your TV to the default TV output channel (channel 3 or 4) and press play on
your VCR.
13