Table of Contents
Advertisement
1. DVB-T Settings
In this category the user is able to adjust several parameters of the modulator RF output part, as described below:
1.1
Channel - Output channel selection (VHF:5-12 & UHF:21-69)
1.2
Bandwidth - Bandwidth selection
1.3
Constellation - Constellation selection
1.4
Modulation - Modulation selection
Guard Interval - Guard Interval selection
1.5
Code rate - Code rate selection
1.6
2. Encoder settings
In this category the user is able to adjust parameters of the H.264 encoder, as described below:
2.1
Input source - Select the primary input source
2.2
Video BR (Mbps) - Set the video bitrate
2.3
Audio BR (Kbps) - Set the audio bitrate
2.4
Audio Encoding – Select the audio encoding
2.5
HDCP ON/OFF – Enables/disables HDCP
3. Multiplexer settings
In this category the user is able to adjust parameters of the V40-10HDMI multiplexer, as described below:
3.1
Network Name + ID - Enter the Network name + ID*
3.2
Program Name + ID - Enter the Program name + ID
3.3
Provider Name - Enter the Provider name
3.4
Original Net ID - Set the Net ID (0-65535)*
3.5
TS ID - Set the Transport Stream ID (0-65535)*
3.6
PMT PID - Set the PID value
3.7
Video PID - Set the Video PID value
3.8
Audio PID - Set the Audio PID value
3.9
LCN No - Set the LCN No (1-999) (must be enabled first)
3.10
LCN Provider - Set the LCN provider
Caution!!!
● Modulation settings must be applied with care and in order to have adequate output bitrate. The output bitrate (which can be
calculated from the tables in Appendix B) must be equal or greater than the total sum of the bitrate of the encoders.
Example: Assuming we select the following modulation settings:
Modulation:
Constellation:
Code Rate:
Guard Interval:
Bandwidth:
We have an output bitrate of 20.107 Mbps according to Appendix B.
This means that encoder's bitrate must be adjusted in such a way that the total bitrate of the encoder does not exceed the
20.107 Mbps limit, otherwise artifacts may occur.
For example, one valid selection in case of four encoders would be to set each encoder bitrate to 5 Mbps since:
4 x 5 Μbps = 20 Mbps < 20.107 Mbps
* TS ID must always be different between DVB-T modulators in the same network.
4. System Settings
This category depicts information about the system's settings as follows:
Status - Depicts the status of the modulator (Idle or Running)
4.1
4.2
FW Version - Depicts the firmware version of the uP
4.3
SW Version - Depicts the software version of the DVProbe
4.4
HW Version - Depicts the hardware version of the V40-10HDMI
4.5
Serial number - Depicts the serial number of the device
8K
16-QAM
5/6
1/32
8 MHz
Advertisement
Table of Contents
