Table of Contents
Advertisement
APPENDIX Α
The V40-10HDMI offers a USB interface with the appropriate software (DVProbe.exe) for advance programming.
The software can be found on the CD that accompanies the V40-10HDMI.
System requirements
●
Windows XP (SP1 or higher)
●
Windows Vista
●
Windows 7 (32 & 64 bit)
●
Windows 8 (32 & 64 bit)
●
Windows 10 (32 & 64 bit)
Device connection via software
1. Insert the supplied software CD into your CD-ROM drive.
2. Connect the V40-10HDMI via the USB cable (A-male to B-male type)
3. In case Windows cannot install the USB drivers automatically, when prompt, insert the correct path of the CD folder
named "USB drivers", which contains the V40-10HDMI USB drivers.
4. Once Windows has successfully installed the USB drivers of the V40-10HDMI, a pop-up message appears to verify this
process.
5. Run the DVProbe.exe file and the main screen will appear (Figure 2.):
Software guidelines
1. From the "ComPort" combo box choose the correct USB port that connects the V40-10HDMI and press "Connect".
2. Once the software has successfully connected with the device, it will automatically download all the settings of the
V40-10HDMI.
3. The DVProbe consists of four sub-categories as described below:
●
DVB-T Settings – Parameters regarding the modulator part
●
Encoder Settings – Parameters regarding the H.264 encoder
●
Multiplexer Settings – Parameters regarding the multiplex part
●
System Settings – Parameters regarding system information
Figure 2. Main screen
Advertisement
Table of Contents
