Irda Connector(Cn7) - Aaeon PCM-6897/L Manual

Compact Board
Normally, the parallel port is used to connect the board to a printer.
The PCM-6897/L includes a multi-mode (ECP/EPP/SPP) parallel
port. It is accessed via CN6 with a 26-pin flat-cable connector.
You will need an adapter cable if you use a traditional DB-25
connector. The adopter cable should have a 26-pin connector on one
end and a DB-25 connector on the other end.
Pin Signal
1 STROBE
3 PTD0
5 PTD1
7 PTD2
9 PTD3
11 PTD4
13 PTD5
15 PTD6
17 PTD7
19 ACK
21 BUSY
23 PE
25 SELECT

2.20 IrDA Connector(CN7)

The IrDA connector (CN7) can be configured to support wireless
infrared module, with this module and application software such as
laplink or Win95 Direct Cable connection, user can transfer files to
or from laptops, notebooks, PDA and printers. Install infrared
module onto IrDA connector and enable infrared function from
BIOS setup. Make sure to have correct orientation when you plug
onto IrDA connector CN7.
Pin Signal
Chapter 2 Quick Installation Guide
P C M - 6 8 9 7 / L
Pin Signal
2 AFD
4 ERROR
6 INIT
8 SLIN
10 GND
12 GND
14 GND
16 GND
18 GND
20 GND
22 GND
24 GND
26 NC
2 - 16