Table of Contents
Advertisement
crimp tool. For crimp head information (including wire preparation, crimping procedures, maintenance and
inspection procedures, as well as repair and replacement procedures) refer to the appropriate instruction sheet
for the associated hand tool and crimping head.
BATTERY TOOL KIT
1213805--1
1213805--2
1213805--3
1213805--4
1213805--5
2. RECEIVING/INSPECTION
The CERTI--CRIMP II Battery Powered Crimp Tool Kit 1213805--[ ] is thoroughly inspected during and after
assembly. Prior to packaging and shipping a final series of tests and inspections is made to ensure proper
function of the tool. The following inspection should be performed as a safeguard against potential problems
generated in transit.
1. In a well--lighted area, carefully uncrate the tool kit and inspect each component as it is removed from
the crate.
2. Thoroughly inspect each component for evidence of damage that may have occurred in transit. If any
of the components are damaged, file a claim against the carrier and notify TE Connectivity immediately.
3. Keep this manual and all drawings and product samples with the tool for the benefit of operation and
maintenance personnel.
The crimp tool should be inspected at regularly scheduled intervals, depending on care, degree of operator
skill, the type and size of product being crimped, and environmental conditions. At a minimum, the tool should
be inspected after every 40 hours of use.
3. INSTALLATION/REMOVAL OF CRIMPING HEADS
CAUTION
Do not operate the tool without the SDE hand tool adapter Installed. Damage to the ram or seals can result.
!
CAUTION
Do not operate the tool without a hand tool crimp head installed. Damage to the adapter can result.
!
CERTI--CRIMP II Battery Powered Crimp Tool Kit 1213805--[ ] comes with SDE hand tool adapter already
installed on the battery powered hand tool. The only installation required is the installation of the crimping
heads.
To avoid personal injury, be sure to exercise extreme caution when handling the crimp tool. Remove the battery before
DANGER
installing or removing crimping heads.
3.1. Installation of Crimping Heads
As supplied, the adapter has three quick--release pins installed (Figure 1). The two outer pins will be used to
secure the two outer housing tabs of the crimp head (exposed portion of the crimp head) to the adapter. The
center pin will be used to secure the movable die of the crimp head to the ram of the adapter.
These pins must be removed prior to installing the crimping head.
1. Remove the battery from the tool.
2. Remove the quick--release pins, described above.
3. Insert the exposed portion of the crimp head into the adapter cavity. See Figure 1.
Rev F
REGION OF USE
BATTERY CHARGER
North America
1725840--1
Europe
1725840--2
North America
1725840--1
Europe
1725840--2
United Kingdom
1725840--3
BATTERY CHARGER
RAM RETRACT
VOLTAGE
110 V
220 V
110 V
220 V
220 V
409- 10055
SWITCH
Yes
Yes
No
No
Yes
5 of 8
Advertisement
Table of Contents
