Remote Control Unit - Samsung DVD-HR725 Instruction Manual

Abnormal HDMI output screen.
If snow noise appears on the screen,
Checkpoint 1
it means that TV does not support
HDCP (High-bandwidth Digital
Content Protection).
HDMI output Jitter
Check your TV system setup
Checkpoint 1
correctly.
Please refer to the user's manual of
Checkpoint 2
your TV.

Remote Control Unit

The remote control doesn't work.
Point the remote control at the remote
Checkpoint 1
control sensor on your HDD & DVD
RECORDER. Allow for proper
distance. Remove obstacles between
your HDD & DVD RECORDER and
the remote control.
Check whether the batteries are
Checkpoint 2
empty.
Check for the TV/DVD selection
Checkpoint 3
button.
Check whether TV control button is
Checkpoint 4
selected or not.
Other
I forgot my password for parental supervision.
Press and hold the
Checkpoint 1
front panel of the Recorder for more
than 5 seconds with no disc in the
unit. All settings including the
password will revert to the factory
settings. Do not use this unless
absolutely necessary. (Note that this
function is possible only when no disc
is inserted.)
Is it possible to change a subtitle and an audio
signal on a recorded disc?
A recorded disc is played with only
Checkpoint 1
the subtitle and the audio signal
which were selected during recording.
Other problems.
Read the table of contents and then
Checkpoint 1
find and read the section describing
your problem, follow the instructions
given.
Plug your HDD &DVD RECORDER
Checkpoint 2
off and on.
If the problem still persists, contact a
Checkpoint 3
nearby Samsung service centre.
button on the
English - 131