Samsung DVD-1080P7 User Manual page 10

Rear Panel
1. DIGITAL AUDIO OUT JACKS
- Use either an optical or coaxial digital cable to connect
to a compatible Dolby Digital receiver.
- Use either an optical or coaxial digital cable to connect
to an A/V Amplifier that contains a Dolby Digital,
MPEG2 or DTS decoder.
2. COMPONENT VIDEO OUT JACKS
- Use these jacks if you have a TV with Component
Video in jacks. These jacks provide P
P-SCAN
- If is set to "ON" in Video Output of the Setup
Menu, progressive scan mode will work.
I-SCAN
- If is set to "ON" in Video Output of the Setup
Menu, interlaced scan mode will work.
3. AUDIO OUT JACKS
Use audio cables to connect to the
your television or audio/video receiver
Note
- Consult your TV User's Manual to find out if your TV supports Progressive Scan (P-SCAN).
If Progressive Scan is supported, follow the TV User's Manual regarding Progressive Scan settings in the
TV's menu system.
- The HDMI output of this unit can be connected to a DVI jack on a
adapter. In this case, it is necessary to use a TV or display with an HDCP-compatible DVI input.
- Refer to the TV's instruction manual for detailed information regarding the TV's HDMI input jack.
- See pages 52 ~ 54 to get more information on how to use the setup menu.
S
E T U P
1
1 3
, P and Y video.
R B
Audio input jacks of
2
4 5
4. VIDEO OUT JACK
- Use a video cable to connect to the Video input jack on
your television.
5. S-VIDEO OUT JACK
- Use an S-Video cable to connect this jack to the
S-Video jack on your television for higher picture
quality.
6. HDMI OUT JACK
- Use an HDMI cable to connect this jack to the HDMI
jack on your television for the best quality picture.
- If an HDMI cable is connected to an HDMI-compatible
TV, HDMI will be output automatically from the player
about 10 seconds later.
TV or other device using a conversion
ENG-10
6