Table of Contents
Advertisement
Available languages
Available languages
Installation and Operation
Methods
Installation Methods
Our company recommends that this unit is installed by trained professionals as the installation process is somewhat complex and requires the use of
various tools. However, if you decide to install this unit by yourself, please refer to the following steps and diagrams
1.Do not exert excessive power when unpacking.
2. Remove tapes attached at the time of shipping to secure parts.
3. Do not tilt the product more than 45° while
moving the product.
4. Place the product on a flat-surface, horizontal
and structurally sound floor.
5. Maintain a sufficient distance from the Wall
to place the unit. At least 20 cm is
recommended.
6. When installing the unit, be sure to use
our genuine parts. Using inappropriate parts
could cause water leakage or damage to the
unit.
20 ®
20 ®
7. Before installing Do not use this product under high water pressure
conditions!
WARNING:
Operating under high pressure conditions may cause the
products' pipes to rupture, resulting in leakage, the machine working
improperly, or even serious property damage. Recommended inlet pressure
is 0.05~0.58 MPa (0.5~5.8 Bars).
In places where inlet water pressure is more than 0.58 MPa (5.8 Bars) it is
recommended to use a pressure reducer before the unit.
8. Close the main feed-water valve before
installation.
9. Open the tap for connecting and remove
the remaining water in piping-system.
10. Detach the faucet from the water pipe and
connect the main water adaptor to the water
pipe.
11.Connect the unit only to the cold water pipe.
It is harmful for filters to connect to hot water.
COLD
HOT
ENG 13
Advertisement
Table of Contents
