Subscribe to Our Youtube Channel
Related Manuals for Certikin SLX
Summary of Contents for Certikin SLX
- Page 1 Certikin SLX Filter Manual Colour and connection details may vary on some models...
- Page 2 English IMPORTANT: This instructions leaflet contains important information regarding the correct installation procedure and use of your bobbin wound sand filters. We therefore recommend that both the installer and users carefully read these instructions before attempting assembly and commissioning. GENERAL SAFTY INSTRUCTIONS These symbols indicate the possibility of danger if the respective instructions are not followed.
- Page 3 CAUTION : For the bobbin wound filter with nozzle plate, the maximum admitted pressure is 1 b under the nozzle plate when back-washing. Fig. 1 1. Air bleed connection 2. Bolted lid 3. Lid ‘O’ ring 4. Conical diffuser 5. Water in 6.
- Page 4 INSTALLATION AND ASSEMBLY Fig. 2 Air bleed Filter RINSE WATER IN Rinse valve Pressure gauge panel With samples taps Butterfly valve FILTERED WATER OUT Pipe support Drain port Before removing the filter from packaging check that it has not been damaged during transport or unloading.
- Page 5 FILTER POSITION The filter base should be positioned on a perfectly flat and level surface. The filter should be installed in a readily accessible place for ease of inspection and maintenance. Fig. 3 À Ecloument Rétour MIn. 60 cm. MIn. 60 cm. INSTALLATION OF THE VALVE BATTERY The valve battery may be supplied with 4 or 5 valves depending on the selected model.
- Page 6 UNLOADING THE FILTER Do not lift the filter by the lid bolts! Fig. 1 Fig. 2 Fig. 3 NO ! O.K. O.K. Check that the filters are correctly positioned. Place the battery and its gaskets correctly to avoid any leakage. Connect up the valve battery, after checking for any transit damage.
- Page 7 Normal pressure when filter is clean: Inlet pressure: 0,6 – 1 bar. Outlet pressure: 0,4 – 0,6 bar When the pressure differential between the two gauges is equal to or greater than 0.5 bar then a backwash should be carried out. BATTERY SUPPORTS Pipe battery supports must be installed to prevent the filter from having to support the weight of the battery and water etc.
Need help?
Do you have a question about the SLX and is the answer not in the manual?
Questions and answers