Programming - Gardena EasyControl Operation Instructions Manual

Fit anti-theft device (optional) [ Fig. I5 ]:
To secure your Water Computer against theft, you
can obtain the GARDENA Anti-theft device Art.
No. 1815-00.791.00 from GARDENA Service.
1. Tightly screw the clamp
p
screw into the circular groove on the rear of
the water computer.

4. PROGRAMMING

Tip:
V Program the Water Computer with the tap
turned off. In this way you can avoid getting
wet.
Enter watering program:
To set the programme, the controller can be remo-
ved and mobile programming can be carried out
(see 3. PUTTING YOUR WATER COMPUTER
INTO OPERATION "Insert battery").
After the battery has been inserted, all program
steps are automatically selected consecutively until
a complete watering program has been entered.
If no program has been entered for 10 min., the
watering cycle switches to „Off".
22
o complete with the
o
2. Use clamp e.g. for fixing a chain.
It is no longer possible to remove the screw after it
has been screwed in.
Set watering duration [ Fig. P1 ]:
The watering duration can be set between 2 to
60 minutes (at 5 minute intervals).
1. Press button.
The symbol flashes under the current watering
duration.
2. Press button until the desired watering dura-
tion is set (example: 30 minutes).
3. Press OK button.
The watering duration is stored.
Setting the watering cycle (day / frequency)
[ Fig. P2 / P3 ]:
The watering days can be set to between daily
(24h) and every 7 days (7th) and the watering
frequency can be set to 1x (every 24 hours),
2x (every 12 hours) or 3x (every 8 hours) respectively
on the watering day.