Replacing The Collar Strap; Resetting The Handheld Device To; Factory Defaults - Garmin PRO 550 PLUS Owner's Manual

9
Replace the six screws to secure the
back plate.
After you install the new battery, charge
the collar completely.

Replacing the Collar Strap

Before you replace the collar strap, you
must remove all dirt, water, and debris
from the device (page 11).
1
Pull the collar strap out of the GPS
antenna, VHF antenna guide, and the
dog device.
You may need to push and pull the
collar strap to properly remove it. You
may need to loosen the screw on the
GPS antenna case, but do not remove
them.
2
Thread the new collar strap hrough
the dog device, VHF antenna guide,
and GPS antenna.
3
If necessary, tigh en the screws that
secure the GPS ant nna case
Resetting the Handheld D vice to

Factory Defaults

You can reset the handheld device to a
default state.
1
Connect the device to a computer
(page 13).
18
The device screen displays
.
2
Move both toggle switches on the
device to their center positions.
3
Set the intensity dial to N.
4
Hold the tone key and the bottom
training key or 5 seconds.
The dev ce displays a check mark and
resta ts.
Appendix