Sony SPP-800 Service Manual page 12

4-1.BASE UNIT SECTION
• Apply 9V dc from regulated DC power supply.
• Perform the adjustment at T3CH (28CH : 49.910MHz) as a rule.
• Set to base unit machine test mode. (Refer to page 7.)
TX Section Adjustment
Note : The electrolytic capacitor (10µF/10V) connected TP23
(DET OUT) to GND. (Only TX section adjustment)
[BASE MAIN BOARD]
(Conductor side)
SECTION 4
ADJUSTMENTS
[BASE MAIN BOARD]
(Component side)
FL101
• Switch position :
S302 (DIAL MODE) : P (pulse)
FL 101
TP23
JR 7
+
10 F
RV101
– 12 –