Subscribe to Our Youtube Channel
Related Manuals for Eden HA33S
Summary of Contents for Eden HA33S
- Page 1 HA33S Wireless alarm system Operation and Installation Manual A PROBLEM? Do not hesitate to call us on our hotline on 0825 560 650. Our technicians will be happy to help you to refine your installation.
-
Page 2: Table Of Contents
CONTENTS Introduction 1. Package Contents HA33S ..................2 2. Installation planning ......................2 3. Installation and programming of the system ............3 3.1 Installation and programming of the alarm center ............... 3 3.1.1 Installing the alarm center ....................3 3.1.2 Programming the alarm center ................... 3 3.1.2.1 Setting the PIN ...................... -
Page 3: Introduction
HA33S system is a standalone alarm system with a built-in telephone dialler, designed to improve the security of your home. The HA33S system protects your home by emitting an audible an alarm if the sensors on the windows or doors, or if the PIR motion detectors are triggered. It can be activated or deactivates by entering a personal code or with a remote control. -
Page 4: Installation And Programming Of The System
Prepare the installation of the alarm system by inserting two screws into the wall 50 mm apart horizontally and at sufficiently high above the ground. - Open the battery compartment on the back of the HA33S. - Insert the 4 alkaline batteries LR06 "AA" type... -
Page 5: Resetting The Pin
3.1.2.2 Resetting the PIN If you forget the PIN, you can reset the alarm center with the factory code without affecting the other settings. To do so, remove the batteries from the alarm center for a few minutes. After replacing the batteries the personal code is again 1234 3.1.2.3 Setting the triggering mode In case of alarm three different triggering modes can be selected with the alarm center. -
Page 6: Key Tones
3.1.2.5 Key tones You can deactivate the alarm center key tones by entering 1234 (or your personal code) followed by To reactivate the beeps, simply repeat the same operation. 3.2 Installation and programming of the accessories 3.2.1 Programming the accessories IMPORTANT: Accessories have a booting delay, it is therefore imperative to insert batteries into each accessory 5 to 10 minutes before you start programming. -
Page 7: Remote Control
3.2.3 Remote control The remote control is used to activate the various functions of your alarm center (Deactivating, Activating without delay time, Activating with delay time, Chime) The remote control is powered by a Lithium CR2032 type battery, which under normal conditions, has a life cycle of over one year. -
Page 8: Opening Magnetic Detector
3.2.5 Opening magnetic detector Installing the detector The detector and magnet can be installed either by using double sided (supplied) tape or screws. Mount the magnet on the door (or window) and the detector (the part containing the battery) on the jamb. The tip of the arrow on the magnet should face the mark on the detector (see picture). -
Page 9: Deleting The Phone Numbers
3.3.3 Deleting the phone numbers The alarm center can not erase each number independently, if you want to delete one number, you have to delete all of them. Which means, after resetting the memory, you will have to reprogram each phone number. -
Page 10: Function Table
Function Table Number sequence to Function Description perform on the alarm center The alarm center rings for 30 seconds and then 1 2 3 4 + 0 1 Triggering mode # 1 stops for 45 seconds. This cycle is repeated 10 times The alarm center remains silent for 45 seconds 1 2 3 4 + 0 2... -
Page 11: Important Tips
6. Problems / Solutions If you have a problem after installing the system, please read the following information: 1. Doors and walls may reduce the detector range to less than 25 meters Alarm center a) Make sure the batteries are properly charge and installed in the compartment provided. b) Make sure your personal code has been programmed properly. -
Page 12: Technical Specifications
TECHNICAL SPECIFICATIONS Alarm center: Radio frequency : 433 Mhz Radio range : 30 meters max. Entry delay time :15 seconds after detection in delay mode Exit delay time :15 seconds after activation Battery type and life cycle : 1.5 volt alkaline (AA) x 4, 1 year life cycle. Low battery indicator (alarm center) The yellow indicator flashes every 30 seconds. -
Page 13: Warranty Card
Fax: 04 92 91 94 45 Zip Code City : Phone: Item ref. : HA33S A PROBLEM? Do not hesitate to call us on our hotline on 0825 560 650. Our technicians will be happy to help you to refine your installation.
Need help?
Do you have a question about the HA33S and is the answer not in the manual?
Questions and answers