Threats; Adjust Oled Alarm Display Brightness - Uniden DFR9 Detailed User's Manual

frequency is detected; however, if a different frequency is detected, the
DFR9 alerts to that different frequency.
When you press MUTE/DIM or the MUTE button on the charger to mute
audio for a specific location, Mute On displays. While Mute On displays,
press MUTE/DIM or the MUTE button on the charger again to save that
GPS location to memory. Mute Mem displays on the screen.
DFR9 registers up to 500 Mute Memory points.
To delete Mute Memory points, press MUTE/DIM or the MUTE button
on the charger while Mute Memory displays. The DFR9 displays a delete
confirmation message; press MUTE/DIM or the MUTE button on the
charger again to confirm. You can also delete Mute Memory points from
Menus/Delete All Mute?

THREATS

The DFR9 detects up to 4 radar band signals (threats) at a single time. The
strongest rader signal is designated as the Priority signal, and its frequency
displays on the OLED. The other signals (threats) are indicated in the left
side of the display. In the following example, 2 K band, 1 X band, and 1 Ka
band frequencies are detected.
X K
The Priority menu setting determines whether Ka band signals have
priority over other signals (see page 13). If Priority is set to Signal
priority, the strongest signal displays on the OLED. If Priority is set to Ka
Priority, the Ka band radar signal displays on the OLED.

Adjust OLED Alarm Display Brightness

The Dark Mode menu lets you adjust the OLED brightness when an alarm
is detected.
1. Press MENU, then press VOL+ until Dark Mode displays.
2. Press MENU to cycle through options for alarm display brightness.
3. Press VOL+ to return to the menus.
K
Ka
24.12 GHz
-24 -