Advertisement
To shim the neck, you must first remove the strings. Next, remove the four screws that hold the neck in place then separate the neck from the body,
(Figure
N).
Note: All finishes remain somewhat elastic. Use care in separating the neck from the body as damage to the finish may occur if the
neck finish has adhered to the body finish. Inadvertent damage caused to an instrument during set-up or adjustment is the responsibility of the
consumer and will not be covered under the
Fender®
warranty.
Place a shim approximately 1/4" wide x 1 3/4" long x .010" thick, (the thickness of a standard business card) at the end of the neck pocket,
(Figure
O), and re-attach the neck. Placing the shim in the neck pocket will effectively lower the string action, and allow approximately 1/32" of additional
saddle height travel.
Note: If you feel you need to make a pitch adjustment and you're not comfortable with the procedure, take your bass to an
authorized
Fender
Service Center.
Figure N
Figure O
21
Advertisement
