Drive Mode; Iso; Drive *1 - Samsung L200 User Manual

Setting up the recording function using the camera buttons

Drive mode

You can select continuous shot, and AEB (Auto Exposure Bracketing).
[Single] ( ) : Take one picture only.
[Continuous] ( ) : Images will be taken
continuously until
the shutter button is
released.
[AEB] ( ) : Take three pictures
in a series in different exposures: standard
exposure (0.0EV), short exposure (-1/3EV) and
over exposure (+1/3EV).
Use this function when you cannot determine the
exposure value of subject.
[Motion Capture] ( ) : This takes 6 shots per second, and for max 5
seconds, when the shutter is pressed and held
down. The maximum number of shots is 30 and
the image size is fi xed as VGA.
High resolution and picture quality increases fi le saving time, which
increases stand-by time.
If the [Continuous], [AEB] or [Motion Capture] sub menu is
selected, the fl ash will be automatically switched off.
If less than 3 pictures are available in the memory, the [AEB]
shooting is not available.
It is best to use a tripod for the [AEB] shooting as the time to save
each image fi le is longer and blurring caused by camera shake
may occur.
If less than 30 pictures are available in the memory, the
[Motion Capture] shooting is not available.

ISO

You can select the ISO sensitivity when taking pictures.
The speed or specifi c light-sensitivity of a camera is rated by ISO
numbers.
[Auto] ( ) : The camera's sensitivity is
automatically changed by
DRIVE
variables such as lighting value
or subject brightness.
Single

[ISO 80, 100, 200, 400, 800, 1600]

(
You can increase the shutter speed while
the same amount of light is present, by increasing the ISO sensitivity.
However, the image may be saturated with light.
The higher the ISO value, the higher the camera's sensitivity to light
and therefore the greater its capacity to take pictures in dark conditions.
However, the noise level in the image will increase as the ISO value
increases, making the image appear coarse.
) :
ISO
Auto
41