Connecting To A Power Source; Recover At Normal Temperature - Samsung ES60 User Manual

Connecting to a Power Source

You should use the rechargeable battery SLB-10A supplied with the
camera. Be sure to charge the battery before using the camera.
SLB-10A rechargeable battery Specifi cation
Model SLB-10A
Type Lithium lon
Capacity 1050mAh
Voltage 3.7V
Charging time Approximately 180 Minutes
Number of images and battery life: Using the SLB-10A
Battery life /
Number of images
Approx. 140 MIN /
Still image
Approx. 280 shots
Movie Approx. 120 MIN
These fi gures are measured under Samsung's standard conditions
and shooting conditions and may vary depending on the user's
methods.
12
Conditions
Using the fully charged battery, Auto
mode, 12M image size, Fine image
quality, Shot to shot interval: 30Sec.
Changing the zoom position between
the Wide and the Tele after every shot.
Using the fl ash on every second shot.
Using the camera for 5 minutes and
then powering it off for 1 minute.
Using the fully charged battery
640x480 image size
30fps frame rate
Important information about battery usage.
When camera is not in use, turn off the power.
Please remove the battery if the camera will not be used
for long periods. Batteries can lose power over time and are
prone to leaking if kept inside the camera.
Low temperatures (below 0°C) can affect the performance
of the battery and you may experience reduced battery life.
Batteries will usually recover at normal temperatures.
During extended use of the camera, the camera body may
become warm. This is perfectly normal.
If you connect the AC adapter to the USB cable, you can use it
as an AC cable and recharge the spare battery with it.
- Using an AC cable
: Connect the AC adapter to the
USB cable. It can be used as a
power cable.
- Using a USB cable
: Remove the AC adapter.You can
download stored images to your
PC (p.86) or supply the power
to your camera through the USB
cable.