Table of Contents
Advertisement
1.2.3
Intended Use
The EE1950 is intended for the measurement of dew point temperature (Td) in applications with
continuous high humidity and condensing conditions. The use of the EE1950 other than described in
this manual is not allowed.
The manufacturer cannot be held responsible for damages as a result of incorrect handling, installation
and maintenance of the device.
Unauthorized modifications of the product lead to loss of all warranty claims. The device may only be
powered with separated extra-low voltage (SELV).
Disclaimer
The manufacturer or his authorized agent can only be held liable in case of willful or gross negligence.
In any case, the scope of liability is limited to the corresponding amount of the order issued to the ma-
nufacturer. The manufacturer assumes no liability for damages incurred due to failure to comply with the
applicable regulations, operating instructions or the operating conditions. Consequential damages are
excluded from the liability.
1.3
Environmental Aspects
Products from E+E Elektronik® are developed and manufactured observing of all relevant requirements
with respect to environment protection. Please observe local regulations for the device disposal.
For disposal, the individual components of the device must be separated according to local recycling
regulations. The electronics shall be disposed of correctly as electronics waste.
1.4
ESD Protection
The sensing elements and the electronics board are ESD (electrostatic discharge) sensitive compo-
nents of the device and must be handled as such. The failure to do so may damage the device by
electrostatic discharges when touching exposed sensitive components.
1.5
Scope of Supply
• EE1950 according to ordering guide
• Inspection certificate according to DIN EN 10204 – 3.1
2
Product Description
2.1
General
The sensing probe and the electronics of the EE1950 undergo the factory adjustment together and may
not be separated from each other. Do not cut, shorten or extend the probe cable.
The analogue output of EE1950 can be set to voltage or current by Slide switches on the electronics
board (see 4.1).
Operation Manual EE1950 dew point module for high humidity applications
5
Advertisement
Table of Contents
