Quick attach device can be installed using tools ordinarily
available.
Torque all hardware to specifications listed in loader
operator's manual.
Shut off the tractor engine and engage the tractor brakes
during installation.
Only quick attach, skid steer compatible attachments
can be used with the quick attach device. Pin on style
attachments can be used on the loader, but necessitate
removal of the quick attach device and relocation of the
bucket level indicator.
All references to left and right used in these instructions
are as they would appear to the operator standing at the
rear of the unit facing forward.
ASSEMBLING QUICK ATTACH DEVICE
(Figure 1)
1. Quick attach device is pre-assembled at the factory.
2. Unband the quick attach device (1) and wood blocks.
3. Cut wire securing spacers (15) and discard cut wire.
INSTALLING QUICK ATTACH DEVICE
(Figures 1 & 2)
WARNING: Always use a drift and hammer
made of non-sparking material (a shot-filled
mallet is recommended) to install or remove
pins. A steel hammer or drift could generate
flying metal fragments and result in injury.
Always wear safety glasses when using a
hammer to remove or install pins.
1. Fasten quick attach device to lower boom arms and
bucket tilt cylinders using four anti-rotation pins, 3/8 x
3/4" shoulder bolts, and 3/8" lock nuts (supplied with
loader). Place one loose spacer (15) between side
of the rod end of the bucket tilt cylinder and inside of
quick attach ear on each side. (Figure 2)
2. Attach bucket leveling rod indicator (supplied with
loader), to outside of right ear on quick attach as
shown in figure 2. Secure bucket leveling rod indicator
with two 1/8 x 1" cotter pins (supplied with loader).
F-4259
ASSEMBLY MANUAL
Keep With Operator's Manual
DELUXE QUICK ATTACH DEVICE
SKID STEER ATTACHMENT COMPATIBLE
RHINO 2410 LOADER
MOUNTING ATTACHMENT TO LOADER
(Figures 1 & 2)
WARNING: To avoid injury during installa-
tion of the loader attachment, do not allow
bystanders within 10 feet of loader or attach-
ment.
1. Locate tractor and attachment on level ground.
Lower boom to rest on the ground. Extend the bucket
cylinders slightly, while raising the boom to provide
three to five inches of ground clearance, drive the
tractor ahead slowly toward the attachment, aligning
the loader quick attach device as shown in figure 2.
2. While driving the tractor ahead slowly to maintain
contact with the attachment, activate the lift cylinders
to raise the loader until the quick attach engages
under the attachment lip.
3. Then activate bucket cylinders to retract, continuing
to roll the attachment back completely.
4. Place tractor in neutral, set parking brake, shut
off tractor. Move latch pin handles to latch (down)
position (refer to figure 2).
5. Start tractor activate lift cylinders to raise attachment
one or two feet off the ground and extend bucket
cylinders to tilt attachment at a slight downward angle,
so quick attachment latch pins are visible. Visually
inspect the attachment mechanism to verify that the
pins are engaged through the latch plate on the back
of the attachment.
NOTE: If the attachment is not securely attached,
follow the instructions for detaching it and repeat the
above procedure.
Page 1 of 4
2-7702
06-02-09