Setting Up Your Remote Control To Operate Your Cable Box - Samsung TXK 3676 Owner's Instructions Manual

S
P E C I A L

Setting Up Your Remote Control to Operate Your Cable Box

1
Turn off your
cable box.
2
Press the CABLE button on the top right of your remote control.
3
On your Samsung remote control, press SET.
4
Enter three digits of the cable box code listed below for your
brand of cable box.
5
Press POWER. Your cable box should turn on. If your cable
box turns on, your remote control is now "set up" correctly.
6
Once your remote control is set up, press the CABLE button any
time you want to use the remote to operate your cable box.
Cable Box Codes
4.3
C F : S F
HAPTER OUR PECIAL
F
E AT U R E S
EATURES
The remote control has four "modes":
"TV," "VCR," "DVD" and "CABLE". Press
the "CABLE" button to switch the remote
control to the "Cable" mode.
Make sure you enter three digits
of the code, even if the first digit is a
"0." (If more than one code listed, try
the first one.)
If your cable box does not turn on,
repeat steps 2, 3, and 4, but try one of the
other codes listed for your particular brand
of cable box. (If no other codes are listed,
try each cable box code, 000 through 077.)
When your remote control is
in the "CABLE" mode, the volume
buttons still control your TV' s volume.
Also, the VCR control buttons (PLAY,
STOP, etc.) will still operate your VCR.