Table of Contents
Advertisement
AA68-03173A_00(E)-CHAPTER 4
S
P E C I A L
Setting Up Your Remote Control to Operate Your Cable Box
1
Turn off your cable box.
2
Press the MODE button and make sure that the CABLE LED
is illuminated.
3
On your Samsung remote control, press the SET button.
4
Enter 3 digits of the cable box code listed below for your
brand of cable box.
5
Press the POWER button. Your cable box should turn on. If your
cable box turns on, your remote control is now "set up" correctly.
6
Once your remote control is set up, press the MODE button
any time you want to use the remote to operate your cable
box.
Cabl Box Codes (CT29K10MQ)
10/24/03
9:59 AM
Page 41
F
E AT U R E S
The remote control has four
"modes": "TV", "VCR", "Cable" and
"DVD".
Press the "MODE" button to switch the
remote control to the "Cable" mode.
Make sure you enter 3 digits of the
code, even if the first digit is a "0." (If
more than one code listed, try the first
one.)
If your cable box does not turn on,
repeat steps 2, 3, and 4, but try one of the
other codes listed for your particular
brand of cable box (If no other codes are
listed, try each cable box code, 000
through 077).
When your remote control is
in the "CABLE" mode, the volume but-
tons still control your TV' s volume. Also,
the VCR control buttons (PLAY, PAUSE,
etc.) will still operate your VCR.
41
Advertisement
Table of Contents
