Troubleshooting - Bio Design User Manual

Portable Air Conditioner

Troubleshooting

If you experience any issues with the air-conditioner, please refer to this table to see if you can
troubleshoot and correct the problem yourself.
Problem
Air condi ti oner will not operate at all
Unit is not starting when pressing
ON/OFF
Air is blowing out, but the cooling
isn't very effective
Noise or vibration
If you have further issues with the air-conditioner or these suggested solutions do not help,
please contact the customer support team.
Do not dispose of electrical appliances as unsorted municipal waste. Use
separate collection facilities. Contact your local government or council for
information regarding the collection systems available.
If electrical appliances are disposed of in landfills or dumps, hazardous
substances can leak into the groundwater and get into the food chain,
damaging health and well-being.
E&OE E&OE
Possible Cause
Power is not turned on at the wall.
Fuse has burnt out.
Start-up timer has not been triggered.
Unit was just recently turned off and
the compressor is cooling down.
Room temperature is lower than the
setting temperature.
Temperature setting is incorrect.
Air filters are blocked.
Air inlet or outlet is blocked.
Air-conditioner has been turned on
inside a very hot room.
Cooling capacity is insufficient
Doors or windows are open.
Ground is not level or flat enough.
©2017 Bio Design ©2017 Bio Design
Bio Design
Possible Solution
Switch the powerpoint on.
Replace the fuse.
Wait or delete the original setting.
Wait for three minutes before
attempting to start again.
Reset the temperature.
Set the proper temperature, making
sure the temperature set is lower than
the ambient temperature.
Clean the air filters.
Remove the obstacle.
Allow additional time for the air-
conditioner to remove all of the heat
stored in the room.
If the room being cooled down is too
large the air-conditioner, then it may
not have the power required to do the
task.
Close the doors and windows.
Move the air-conditioner to a flatter,
more level area of flooring.
9 9