Chapter 2: Installation; Connecting Vhf And Uhf Antennas; Antennas With 300-Ohm Flat Twin Leads - Samsung CL29Z40MQ Owner's Instructions Manual

I
N S TA L L AT I O N
C h a p t e r Tw o
I
N S TA L L AT I O N

Connecting VHF and UHF Antennas

If your antenna has a set of leads that look like this,
see "Antennas with 300-ohm Flat Twin Leads"
below.
If your antenna has one lead that looks like this,
see "Antennas with 75-ohm Round Leads" on page
14.
If you have two antennas, see "Separate VHF and
UHF Antennas" on page 14.

Antennas with 300-ohm Flat Twin Leads

If you are using an off-air antenna (such as a roof antenna or "rabbit ears") that has
300-ohm twin flat leads, follow the directions below.
1
Place the wires from the
twin leads under the screws
on the 300-75 ohm adapter
(not supplied). Use a
screwdriver to tighten the
screws.
2
Plug the adapter into the
"ANT 1 IN (AIR)" terminal on
the rear panel.
English - 13