Makita XSL03 Instruction Manual page 29

Crown molding stopper
Optional accessory
Crown molding stoppers allow easier cuts of crown
molding without tilting the saw blade. Install them on the
turn base as shown in the figures.
At right 45° miter angle
1
► 1. Crown molding stopper L 2. Crown molding stop-
per R 3. Turn base 4. Guide fence
At left 45° miter angle
1
2
3
► 1. Crown molding stopper L 2. Crown molding stop-
per R 3. Turn base 4. Guide fence
Position crown molding with its WALL CONTACT EDGE
against the guide fence and its CEILING CONTACT
EDGE against the crown molding stoppers as shown in
the figure. Adjust the crown molding stoppers according
to the size of the crown molding. Tighten the screws to
secure the crown molding stoppers. Refer to the table
(C) for the miter angle.
1
2
3
4
► 1. Guide fence 2. Crown molding stopper
1. Inside corner 2. Outside corner
Table (C)
4
–
For inside
corner
For outside
corner
29 ENGLISH
(a) (b) (c) (d)
1 2
Molding Miter angle
position in
the figure
(a) Right 45°
(b) Left 45°
(c)
(d) Right 45°
2
Finished
piece
Save the right
side of blade
Save the left
side of blade
Save the right
side of blade
Save the left
side of blade