Table of Contents
Advertisement
When installing the product on a console or
shelf, make sure that the front of the product
does not protrude out of the console or shelf.
•
Otherwise, this may cause the product to
fall off and result in a malfunction or
injury.
•
Make sure to use a cabinet or shelf
suitable to the size of the product.
If the product is installed in a location where
the operating conditions vary considerably, a
serious quality problem may occur due to the
surrounding environment. In this case, install
the product only after consulting one of our
service engineers about the matter.
•
Places exposed to microscopic dust,
chemicals, too high or low temperature,
high humidity, such as airports or
stations where the product is
continuously used for a long time and so
on.
Cleaning Related
Since using a surfactant, which contains a large amount of alcohol, solvent or other strong chemicals, may result
in the discoloration or cracking of the product exterior or the panel surface coming off, be sure to use the recom-
mended cleansing agent only.
You can purchase the recommended cleansing agent from a service center.
Before cleaning the product, unplug the
power cord.
•
Otherwise, it may result in electric shock
or fire.
Caution
Avoid spraying cleansing agent directly onto
the product.
•
This may result in discoloration or
cracking of the exterior of the product or
the panel coming off.
Use a soft, damp cloth with a "monitor-exclu-
sive cleansing agent" and wipe the product
with it.
•
If no monitor-exclusive cleansing agent is
available, dilute a cleansing agent with
water at a ratio of 1:10 before cleaning
the product.
Major Safety Precautions
When putting the product down, handle it
gently.
•
Otherwise, it may result in a problem with
the product or injury.
When cleaning the product, do not spray
water directly over the product parts.
•
Make sure that water does not enter the
product.
•
Otherwise, it may result in fire, electric
shock or a problem with the product.
When cleaning the product, disconnect the
power cord and clean the product with a soft
dry cloth.
•
Avoid using chemicals such as wax,
benzene, alcohol, thinner, mosquito-
repellent, fragrance, lubrication or
cleansing agent when cleaning the
product.
This may result in the exterior being
deformed or the print being removed.
Since the exterior of the product is easily
scratched, be sure to use a proper cleansing
cloth. Use the cleansing cloth with a small
amount of water. However, if the cloth is
contaminated by alien substances, it may
result in scratches to the exterior; therefore
shake off any alien substances from the
cloth before using it.
1-3
Advertisement
Table of Contents
