Electrical Connections And Operations; Lubrication - Ramsey Winch RE8000 Owner's Manual

MAINTENANCE
(continued)
Spool the cable properly on the drum when storing between each usage. Check the oil
level in the gear boxes every six months. At the same time, check electrical connections
and mounting bolts - tighten if necessary.
Corrosion on electrical connections will reduce performance or may cause a short.
Clean all connections, especially in remote switch receptacle. In salty environments
use a silicone sealer to protect from corrosion.
Be sure the winch has plenty of battery power avail able.
Fill worm gear box with 3/4 pint of SAE 140 EP.
Use 1/2 pint of SAE 20 for spur gear box. Apply cup grease to lube fi tting at top of clutch
housing. Should winch be submerged for a brief period, drain oil, fl ush and replace oil in
gear boxes, and grease all fi ttings (see Troubleshooting Guide on page 7).
To minimize corrosion of the internal motor components that may occur due to conden-
sation, power the winch in or out periodically. Energizing the motor will generate heat,
which will dissipate any moisture buildup in the motor. This should be performed at peri-
odic intervals (such as with each oil change to your vehicle).
Lubricate cable periodically using light penetrating oil.
Inspect for broken strands and replace if necessary with Ramsey part number listed in
Parts List.
Install new cable per "Cable Installation" page 5.
6