Table of Contents
Advertisement
and 'Password' of the 'Remote Desktop' with those of the host PC.
I cannot access the
1) Check if the Hub port LED to which the LAN cable is connected blinks. If not,
Internet in the
that indicates that the LAN connection is disconnected. In this case, connect
Client screen.
using another LAN cable.
2) Check if the settings of the 'Network' tab of 'Settings' have been properly set
up. The default setting is "DHCP". If your network uses a static IP address,
select 'Use the following IP address' and then enter the appropriate IP address
information.
The contents
This is because the data is transmitted over the LAN. Check your LAN
(video, voice) on
connection status.
the server do not
play smoothly on
the Client Monitor.
I have connected a
This model supports USB devices that support removable disk functions without
digital device such
an additional driver installation. Check if the device you want to connect to is a
as a digital camera,
device that supports the removable disk function without an additional driver
camcorder or USB
installation.
memory to the USB
port, but they do
not work.
The file list does
1) Check the files on the card. If only abnormal files (e.g. 0KByte, broken JPEG)
not appear.
exist, the files do not appear on the screen.
2) The time required to display is determined by the size of the file. Wait a
moment.
3) Check if the format of the file is supported by the Client Monitor. If the
extension of the file has been changed, the file will not be played.
Check the following items if there is trouble with the monitor.
Check if the power cord and the video cables are properly connected to the computer.
Check if the computer beeps more than 3 times when booting.
(If it does, request an a service for the main board of the computer.)
If you installed a new video card or if you assembled the PC, check if the installed the adaptor(video)
driver and the monitor driver.
Check if the scanning ratio of the video screen is set at 56 Hz ~ 75 Hz.
(Do not exceed 75 Hz when using the maximum resolution.)
If you have problems in installing the adaptor (video) driver, boot the computer in Safe Mode, remove
the Display adaptor at the "Control Panel → System → Device Administrator" and then reboot the
computer to reinstall the adaptor (video) driver.
If problems repeatedly occur,
Q & A
Question
How can I change the frequency?
contact an authorized service
Answer
Frequency can be changed by reconfiguring the
video card.
Note that video card support can vary, depending on
the version of the driver used.
(Refer to the computer or the video card manual for
details.)
center.
Advertisement
Table of Contents
