Advertisement
Available languages
Available languages
WARNINGS
Before installing the appliance, make sure
that none of the parts are damaged in any
way. In case of damaged parts, contact your
retailer and do not proceed with installation.
Read all of the following instructions with
care before installing the appliance.
- Use an air outlet pipe of the shortest
possible length.
- Limit the number of pipe bends.
- Use a material approved by standards and
regulations.
- Avoid any sudden changes in pipe section
(recommended constant diameter: 150 mm
or equal surface area).
* The appliance is not intended for use by
young children or infirm persons without
supervision. Young children should be
supervised to ensure they do not play
with the appliance.
* The extractor hood must be a minimum
distance of 65 cm from all hobs.
* The extracted air can't be conveyed
through or into a duct used to let out
fumes from appliances fed by energy other
than electric power (eg. centralized heating,
radiators, water heaters, etc.).
* To evacuate the air outlet, please comply
with the pertaining rules given by
competent authorities.
* Provide the room with an adequate aeration
when a cooker hood and appliances fed by
energy other than electric power (gas, oil, or
coal stoves, etc.) are used simultaneously. The
cooker hood, when evacuating the extracted air,
could generate a negative pressure in the
room which can't exceed the limit of 0.04
mbar, in order to avoid the suck of exhausts
deriving from the heat-source. Therefore the
room should be provided with air-intakes to
allow a constant flow of fresh air.
If the rating label in the cooker-hood
shows the symbol , the appliance is
built in class II° and it does not need any
earth connection.
If the rating label in the cooker-hood does
not show the symbol , the appliance is
built in class I° and it needs the earth
connection.
* When performing the electrical connections
on the appliance, please make sure that the
current tap is provided with earth connection
and that voltage values correspond to those
indicated on the rating label placed inside the
appliance itself.
* Before carrying out any cleaning or
maintaining operations, the appliance
needs to be removed from the electric grid.
If the appliance is not provided with a non
separable flexible cable and plug, or with
another device ensuring omnipolar
disconnections from the grid, with an
opening distance between the contacts of at
least 3 mm, then such disconnecting devices
must be supplied within the fixed installation.
If the fixed appliance is endowed with a
supply cord and a plug, the appliance has to
be put in a place where the plug can be
reached easily.
* The use of materials which can burst into
flames should be avoided in close
proximity of the appliance. When frying,
please pay particular attention to fire risk
due
to
oil
inflammable, fried
dangerous.
Do
electric grills. In order to avoid possible
fire risk, all instructions for grease-filter
cleaning and for removing eventual grease
deposits should be strictly followed.
The appliance is already arranged both for
filtering and for suction performances.
* In its filtering version (Fig.1), the air and
fumes conveyed by the appliance are cleaned
both by a grease filter and by an active
charcoal filter, and put again into circulation
through the hole made on the top of the
cabinet.
The charcoal filter is not supplied with the
appliance, and must be ordered separately if
required
11
grease.
Being
oil
is
especially
not
use
uncovered
USES
highly
Advertisement
