Ohlins SU 145 Owner's Manual

F1
R1
R2
Bike on a stand. Bike on the ground.
Setup data
Shock absorber length 330.5
(+10/-0)
Shock absorber stroke 83 mm
Spring preload 16 mm
Rebound damping adjuster 12 clicks
Compression damping adjuster 02 clicks
Öhlins Racing AB, Box 722, S-194 27 Upplands Väsby, Sweden.
Phone +46 8 590 025 00. Fax +46 8 590 025 80.
F2
R3
Bike with rider on.
Checking sag and ride height
mm
Front suspension
F1. Bike on a stand with the
suspension fully extended
F2. Bike on the ground without rider = ............
F3. Bike on the ground with rider
F1 - F2 = ............
Free sag
F2 - F3 = ............
Ride height
Rear suspension
R1. Bike on a stand with the
suspension fully extended
R2. Bike on the ground without rider = ........... .
R3. Bike on the ground with rider
R1 - R2 = ............
Free sag
R2 - R3 = ............
Ride height
NOTE!
If ride height is higher than recommended,
softer spring/springs must be used.
If ride height is lower than recommended,
harder spring/springs must be used.
Contact your Öhlins dealer for advice.
www.ohlins.com
F3
Compression
damping adj.
= ............
= ............
= ............
= ............
© Öhlins Racing AB. All rights reserved. Any reprinting or unauthorized use without the
Owners Manual
Mounting instructions Öhlins shock absorber kit
SU 145 for Suzuki GSX 1100
Öhlins shock absorber 36 PRCLB
Your Öhlins shock absorber type 36 PRCLB features
the following adjusters:
Compression damping adjuster
Adjustments are made with the wheel on top of the
reservoir. The adjustments are made in four (4) steps.
Rebound damping adjuster
Adjuster wheel on the piston shaft above the end
bracket.
Spring preload adjuster
Spring
Adjustments are made by turning the knob on the hy-
preload
draulic adjuster. Clockwise for harder adjustment,
adjuster
counter clockwise too release the preload.
Lenght adjuster
Adjustment is made by turning the end eye and tight-
ening with the lock nut.
NOTE!
When delivered the Öhlins shock absorber is dialed to
recommended settings for the specific brand and make
Rebound
of the motorcycle. If you have changed the setting
damping
check like this:
adjuster
Lenght
The adjusters have a normal right hand tread. Turn the
adjuster
damping adjusters clockwise to fully closed (pos. zero [0]).
Turn counter clockwise to open and count the clicks until
you reach the recommended number of clicks. See Setup
data at page 4.
CAUTION!
Do not use to much force, delicate sealing surfaces
can be damaged.
written permission of Öhlins Racing AB is prohibited. Printed in Sweden.