Page 1
8 Channel mA Input Station Overview The Intech Micro 2300 series is a system of modular I/O Remote Stations, that add an even lower cost option to Intech’s already extensive intelligent I/O Remote Station family, which connect automatically to the Intech MicroScan V5 logging plus SCADA software package.
Page 2
Section A: 2300-A8II Installation Guide Index. Section A: Description, Ordering and Specifications. Index. Page 2 Features, Description and Ordering Information. Page 3 Specifications. Dimensions. Page 4 Section B: Station ID Tables. Station ID Tables. Page 5 Section C: Status Indicators.
Page 3
2300-NET : Isolated Ethernet to RS485. Description. The 2300-A8II remote station has 8 isolated current inputs. The inputs are fully isolated from input to logic and between inputs. This station is ideal for monitoring existing 4~20mA current loops which are isolated from each other and cannot be connected to a common point of reference.
Page 4
2300-A8II Dimensions. The 2300-A8II enclosure is shown below. The station clips directly onto an industry standard DIN rail. Field wiring is on the top of the station via a separate plug in connector. The station power and RS485 communications wiring are on a separate plug in connector on the side of the housing.
Section B: Station ID Table. The following table assists with the setting up of DIP switches for the required Station ID (Station number). STATION STATION DIP SWITCH SETTINGS DIP SWITCH SETTINGS 14.22-5...
RS485 Rx Power RS485 Tx Input Status 1 - 8 Switch 1 Switch 10 2300-A8II Power and RS485 Comms Wiring. Connection 12Vdc @ 58mA + 24Vdc @ 31mA + Comms RS485 Warning: If the power/communication connections are reversed, the remote station may become faulty.
If using the USB485 converter, do not connect to the computer until after MicroScan has been installed. MODBUS Applications: If using the 2300-A8II station in other applications where MODBUS is required, please refer to the 2300-A8II MODBUS supplementary manual which is available for download from the Intech website: www.intech.co.nz/2300...
Page 8
Do not mount in cabinets with power control equipment. To maintain compliance with the EMC Directives the 2300-A8II is to be mounted in a fully enclosed steel fire cabinet. The cabinet must be properly earthed, with appropriate input / output entry points and cabling.