Configure I-View Now Entry Delays; Test Settings - Gen IV Technology HDE-X Installation Manual

Configure I-View Now Entry Delays

Entry Delays are configurable through the I-View Now Dealer Portal. Log in to configure.

Test Settings

Once the DVR has been properly configured and the necessary settings entered into the i-viewnow.com portal, it is a
good idea to test each alarm input on the DVR by triggering the corresponding device on your alarm panel.
If relay 1 is connected to input 1 on the DVR and it is supposed to trigger when a panic button is pushed, ensure not only
that the DVR has received the signal. Also ensure that the I-ViewNow.com portal has received the signal and correctly
identifies the type of alarm.
© 2013 I-View Now, LLC. All Rights Reserved.
Gen IV HDE-X Installation Guide rev 1.1 Page 13