Raycap 3315-ALM-RS485 Installation Instructions Manual page 12

3315-ALM-RS485
Procedure
Installation of 3315-ALM-RS485 (continued)
10.2 The power wire is secured to frame. In order for the power wire to reach the connection
terminal, the cable tie must be clipped.
10.3 From the backside of the unit, carefully
the Power wire connection terminal. This will minimize the chance of damaging the
power wire.
Power Wire
connection terminal
Power Wire
(secured to frame)
©Raycap • All rights reserved
320-1261 Rev.C
Page 12 of 24
INSTALL INSTRUCTIONS
Figure 10.2
Figure 10.3
clipping cable-tie on
back-side of unit
clip the cable tie to allow cable length to reach
(indicating to clip cable-tie on
the back-side of unit)
www.raycap.com